Polaris Vac-Sweep 360
Operates without a separate booster pump
SKU #F1
The Polaris 360 easily connects to a dedicated pressure line and is suitable for all in-ground pools. It sweeps, scrubs, and vacuums all surfaces of the pool. It also traps large debris like leaves and pebbles in its own filter bag. The Polaris Vac-Sweep® 360 features advanced technology cleaning without the need for a separate booster pump.
Our Most Advanced Pressure Pool Cleaner
- Vacuums, sweeps and scrubs the bottom and walls of any size or shape pool.
- In-line back-up valve automatically frees the 360 if it gets cornered and keeps it cleaning without interruption.
- Powered by the pressure of clean water returning to your pool, leaving both the filter and skimmer free to eliminate contaminants.
- Unique filter bag removes debris before it reaches your pump basket or filter, prolonging the life of your filtration system.
- Available in a Black Max Model to complement dark bottom pools.
Polaris Vac-Sweep 360 Specifications
Polaris Vac-Sweep 360 User Guides
Polaris Vac-Sweep 360 Frequently asked questions
Verify the wheel RPM's are in range. If they are low or the wheels are not spinning then check the in-line filter for debris. If clear and the wheels still aren't spinning then check the water management system for clogs. If the RPM's are slightly below the prescribed range then remove the restrictor disc from the wall connector. If the wheels are moving too quickly then install the red restrictor disc.
Verify the wheel RPM's are in range. Ensure that the head float is not filled with water. Try running the cleaner without the bag and if it fixes the issue then clean the bag with soap and warm water. This will remove any biofilm/oils that may have accumulated in the bag.
Verify that the wheel RPM's are in the correct range and adjust the thrust jet. If the cleaner isn't climbing well then ensure the thrust jet is in the 11 o'clock position. If it is going in circles then angle the thrust jet so it is pointing opposite of the way the cleaner is turning. For example, if the cleaner is turning right then point the thrust jet to the left.
Check swivels and make sure they are spinning freely. Lay the hose out in the sun for 24 hours to eliminate any potential hose memory.
Hold the back up valve out of the water and verify that it cycles on and off. A complete cycle takes about three minutes. If it stays on all the time or doesn't come on at all then replace the back up valve.
- Check the filter bag, if full it can weigh the cleaner down on one side.
- Remove the head float and shake it. If there is water in the float, order a new one.
- The feed hose should float evenly on the surface of the pool.
